•Seek the Challenging Position of Electrical Installer/Technician
oA highly talented Electrical Installer with huge experience in performing installation and
checkout on a variety of systems utilizing codes, company procedures, engineering drawings
and personal analysis; working with "Prime" electrical contractors as required and developing
a positive interface with the customer to ensure confidence and satisfaction with the system installation.
Summary of Qualifications
oMore than 3 years experience.
oDemonstrated ability to read and interpret drawings.
oGreat working knowledge of cable routing and connections.
oExceptional ability to determine installation materials.
oDeeply self motivated and strong ability to work independently.
oImmense knowledge of current electrical installation practices.
oIn-depth ability to using a wide range of hand tools.
oDeep knowledge of safe working practices and procedures.
oRemarkable ability to maintain stock inventories.
oUncommon ability to prepare, maintain and repair equipment.
oProfound ability to communicate effectively face to face, on the telephone and in writing.
oIn-depth ability to follow verbal and written instructions.
oProfound ability to make a positive contribution to a team.
oStrong ability to demonstrate tasks/processes to individuals and small groups.
• EDUCATION;
AOA in advanced electronics at Colorado Aero Tech: HSG 87.9, DOG Jan 25, 1999 Denver, CO
•MILITARY: 92A10Y2 AUTOMATED LOGISTICS
HONORABLE DISCHARGE ARMY NATIONAL GUARD OCT 18, 1993
AWARDS: ASR-1, NDSM-1, IESR-1.
•
o
• Professional Experience
 Electrical Installer
• Install raceways, cables and wiring to meet local and national codes, standards and customer system requirements.
• Lay out electrical controls installation to provide lowest total installed cost.
• Mount and terminate controls equipment as needed.
• Mentor and assist others as the local expert regarding electrical installation practices, requirements.
• Determine and validate final termination points to equipment interfaced with the installed system (i.e. cctv, tv, power box, curcuit breakers, etc.).
• Check out wiring and terminations of field-installed equipment with test instruments as needed (i.e. volt meters, hand held testers, etc.).
• Keep management informed of job needs, progress and issues.
• Provide work direction to other employees involved in electrical installation.
• Complete paperwork, including but not limited to time sheets, expense reports, and on-site documentation.
• Provide feedback to JCI Engineering on changes and keep as-built drawings current.
• Resolve job site conflicts regarding installation issues or escalates concerns to management as required.
• Communicate with the customer as necessary upon arrival and before leaving the work site.
• Adhere to safety programs and policies.
• Perform other related duties as assign
o
 FVT/ISC
 James Tiffany
 561-294-5953
 8800 Okeechobee Rd FEB 2007-JULY 2009
 Ft Pierce, Fl 34945


• INSTALLATION TECH
• CABLE INSTALL
• CCTV,SECURITY CAMERAS
• NARROW BAND CHANNELS
• SATELITE TV
• TV AND RECIEVER INSTALLS
• SECURITY SURVEILLANCE SURVEYS
• STENEPHONE INSTALLS
• ELECTRICAL/ AIRCRAFT/INSTALLATION TECH
• SUMMARY OF QUALIFICATIONS
• Worked on:
• TH 67,AB 139,210,430,412,427,407,206 (B,L)
• UH 60(EIBF,BFT,HUMMS,CMS)
• B757(ETOPS),B737,B727,B767
• HUEY 1&2
• C130(H/E,EC)
• GULFSTREAM COMMANDER(695
o SERIES)G4,G4X,G5SP,G200
• PREMIER 1 CORPORATE
• FALCON 50EX/900EX
• S76KING AIR 200/300
• BEECHCRAFT C12J/1900(PASS/CARGO)
• LEARJET J4
• CESSNA CITATION (PROP/JET)
• DC 9
o Beechjet,
o King Air 300, 200, & 90 series, Barons, Bonanzas,
o Cessna Citation 414, 402, 340, 210,185,182,& 172,
o Piper Chieftain, Navajo, Aztec, Seneca, PA32 series and PA28 series.
• Certificates In:
o Bendix/King Equipment; transponder KT 76/78, adf KR 86, digital adf KR 87, dme KNS 80/KN 62/62A, nav com KX 155/165, Flt control KFC 200/KCS 55A, comm KY 196/197
o FMS/GPS-800 SYSTEM Lockheed Martin May 25, 2000
• Summary of Qualifications AVIONICS
o A highly talented Avionic Equipment Service Technician with experience in installing,
o inspecting, testing, adjusting, or repairing avionics equipment, such as radar, radio, navigation, and
o control systems in aircraft .
o More than 10 years experience.
o Great knowledge of the principles, theories, maintenance, and repair of aircraft radio and instrument systems.
o Midlevel knowledge of the practices, methods, equipment and materials used in the installation, maintenance,
o testing and repair of aircraft radio transmitting and receiving equipment,communication and related instruments.
o General knowledge of Federal Communication Commission (FCC) and Federal Aviation Agency (FAA) rules and regulations pertaining to the operation, maintenance and repair of aircraft radio-communications equipment an instrument systems, and the establishment and maintenance of an approved Aircraft Radio and Instrument Repair Shop.
o General skill in the use and operation of tools and test equipment utilized in the maintenance and repair of aircraft radio and instrument systems.
o Uncommon skill in the detection, diagnosis and repair of mechanical, electrical and electronic defects in aircraft radio and instrument systems.
o In-depth ability to interpret and work from technical diagrams and blue prints.
o Remarkable ability to work rapidly in chaotic situations.
o Sound ability to install and maintain a FAA approved repair shop.
o Solid ability to prepare and maintain accurate and timely records and reports.
o Profound ability to work without technical supervision.
•
• Over all avionics qualifications
• Avionic Equipment Service Technician
o Assemble components, such as switches, electrical controls, and junction boxes, using hand tools and soldering iron.
o Connect components to assemblies, such as radio systems, instruments, magnetos, inverters, and in-flight refueling systems, using hand tools and soldering iron.
o Test components or assemblies, using circuit tester, and voltmeter.
o Lay out installation of assemblies and systems in aircraft, according to blueprints and wiring diagrams, using diagram, engineer upgrades and drawings.
o Under supervision set up and operate ground support and test equipment to perform functional flight test of electrical and electronic systems.
o General knowledge to interpret flight test data to diagnose malfunctions and systemic performance problems.
o Install electrical and electronic components, assemblies, and systems in aircraft, using hand tools, power tools, and soldering iron.
o Adjust, repair, or replace malfunctioning components or assemblies, using hand tools and soldering iron.
o Approve and certify all work done to aircraft radio and instrument systems.
• Assistant Avionic Equipment Service Technician
o Assisted in the design, installation and maintenance of a Federal Aviation Agency approved Aircraft Radio and Instrument Repair Shop.
o Under supervision and training tested radio transmitters and receivers, using such instruments as frequency meters, signal generators.
o Isolated and diagnosed defects; repaired and replaced defective parts.
o Used frequency meters to determine if transmitter was operating on the designated frequency and made necessary adjustments to insure correct frequency and maximum output.
o Assisted in the design of instrument location and instrument systems on aircraft to maintain proper aircraft balances and maximize ease of installation, maintenance, and repair of such equipment and systems.
o Worked on upgrades for intercom, navigation, and emergency locator beam systems and directed and participated in the installation of some on aircraft.
o Maintained adequate inventory of all parts and supplies utilized in the repair shop.
o Assisted in the preparation and maintenance of all reports and records required by the FAA and the agency administrative units.
o Performed related duties as required.
• Individual Company Professional Experience
o PENINSULA AVIONICS-FT. PIERCE, FL DEC 2006-MAR 2007
o 772-461-5104
o 3060 AIRMANS DR
o FT PIERCE, FL 34945
• Worked on:
 Beechjet, King Air 300, 200, & 90 series, Barons, Bonanzas,
 Cessna Citation 414, 402, 340, 210,185,182,& 172,
 Piper Chieftain, Navajo, Aztec, Seneca, PA32 series and PA28 series.
o Built, inspected, and rung out fabricated harness:
o TAS 600, G430, G530, PMA 3000/1000, 340, Transponder, Audio panel, PTT switch, and Pilot/Co-pilot Mic jacks, installed and removed indicators, wires and corroded components from aircraft.
o AVSSI-EDWARD & Assoc. PINEY FLATS, TN
• JASON DAY
• 817-789-4275
• P.O.BOX 171024 MAY 2006-OCT 2006
• ARLINGTON,TX 76003-1024
•
• WORKED ON:
• TH 67,AB 139,210,430,412,427,407,206 (B,L)
• TRAINCROFT-WESTWIND HUNTSVILLE,AL
• 803-366-4725
• UNKOWN FEB 2006-MAY 2006
•
• WORKED ON:
• UH 60 (EIBF,BFT,HUMMS,CMWS)
•
• RELIANCE-TIMCO GOODYEAR.AZ
• 866-745-2632
• 1161 MURFREESBORO PIKE JAN 2006-FEB 2006
• STE 410 NASHVILLE,TN 37217
•
• WORKED ON:
• B757 (ETOPS)
•
• PLANETECHS-US HELICOPTER OZARK,AL
• 800-669-5627
• 1520 KENSINGTON RD SEPT 2005-JAN 2006
• STE 311 OAK BROOK, IL 60523
•
• WORKED ON:
• HUEY 1 & 2
• C130
•
• AVSSI-DECRANE GRORGETOWN,DE
o JASON DAY
• 817-789-4275
• P.O.BOX 171024 APR 2005-AUG 2005
• ARLINGTON,TX 76003-1024
•
• WORKED ON:
o BJ737
o GULFSTREAM COMMANDER (695 SERIES)
•
• PLANETECH-AAR INDIANAPOLIS,IN
• 800-669-5627
• 1520 KENSINGTON RD FEB2005-MAR 2006
• STE 311 OAK BROOK, IL 60523
•
• WORKED ON:
• B737
•
• APA-FALCON JET LITTLE ROCK,AR
• 817-560-6675
• 4760 HWY 377 SOUTH JUN 2004-JUL 2004
• FORT WORTH, TX 76116
•
• WORKED ON:
• FALCON 50EX/900EX
•
o HQ AERO-KEYSTONE HELICOPTER WEST CHESTER,PA
• 304-848-0900
• GREENWOOD BUS. PARK JUL 2003-SEPT 2003
• RT 4 BOX 241
• BRIDGEPORT, WV 26330
•
• WORKED ON:
• S76
•
o APA-GULFSTREAM SAVANAH,GA
• 817-560-6675
• 4760 HWY 377 SOUTH DEC 2002-MAY 2003
• FORT WORTH, TX 76116
•
o WORKED ON:
o G4,G4X,G5SP
•
• STROM-GULFSTREAM DALLAS,TX
• 800-743-8988
• 10501 WAYZATA BLVD JUN 2002-JUL 2002
• MINNETONKA,MN 55305
•
• WORKED ON:
• G4,G200
•
• INCONEN-RAYTHEON WICHITA,KS
• 316-722-6774
• 149 S. RIDGE RD AUG 2001-NOV 2001
• WICHITA,KS 67209
•
• WORKED ON:
• PREMIER 1 CORPORATE
•
•
o PHILLIPS AVIATION-TIMCO
• 864-576-6383 SPARTENBURG,SC
• 357 E.BLACKSTOCK DR DEC 2000-JUN 2000
• SPARTENBURG,SC 29301
•
• WORKED ON:
• B737,727,767,C130 H/E (EC)
•
• ONSITE -STEVENS AVIATION
• 864-213-6100 GREENVILLE,SC
• 921 ELKRIDGE LANDING RD JUL 2000-DEC 2000
• LINTHICUM, MD 21090
 WORKED ON:
 KING AIR 200/300, BEECHCRAFT C12J/1900
 PASS/CARGO. LEARJET J4,CESSNA CITATIONPROP/
 JET
•
•
• LOCKHEED MARTIN GREENVILLE.SC
• 864-299-7123
• 105 EDINBURGH COURT JAN 2000-JUL 2000
• GREENVILLE,SC 29607
•
• WORKED ON:
• DC 9
•
• TECHNICAL
o Profound ability to read and understand mechanical drawings, cable/harness diagrams, manufacturing procedures and test procedures.
o Exceptional ability to lift 50lbs.
o Remarkable ability to maintain and calibrate electronic test equipment.
o Keen abilities to understand, analyze and draw conclusions from test results and present these in test reports.
o Midlevel knowledge of RF assembly and testing.
o In-depth skills in PA testing, tuning, and modification.
o Strong hands-on abilities in RF and microwave testing.
o Excellent communication skills; oral and written.
o Profound ability to work independently and in a team.
o General computer skills including Excel and PowerPoint for data formatting.
o Organized the test operators, assembly, inspection, data research teams.
o Worked with engineering staff on a more productive computer drive testing and logging data.
o Excellent with inventory, shipping, receiving, supply.
o Strong skills as quality control including computer boards for defaults, non functioning parts, bad soldering joints.
o STORAGE TEK BRUCE RYDER AUG 1998-MAY 1999
o One Storage Tek Dr 303-661-5147 graduated
o Mail Stop 4274
o Louisville, CO 80028
o PC PERIPHERALS JOHN CORTE APR 1998-AUG 1998
o 3401 Industrial LN 303-439-8650
o Unit E
o Broomfield, CO 80020
NukeJobs is a nuclear jobs board that provides nuclear job seekers access to international directories of Nuclear Employers, Nuclear Resumes and Nuclear Jobs such as Nuclear Engineer Jobs, Nuclear Construction Jobs, Nuclear Power Plant Jobs, Nuclear Medicine Jobs, Nuclear Pharmacy Jobs, Nuclear Security Jobs, Nuclear Physics Jobs, Nuclear Reactor Jobs, Nuclear Material Jobs, Nuclear Safety Jobs, and Nuclear Waste Jobs.